Forum › TEKNIK › Ninety, OneTen & Defender › Defender (1999-2006) TD5-Storm, 3.9L V8 › Oil Leak Tracking
- Detta ämne har 16 svar, 5 deltagare, och uppdaterades senast 2021-04-05 19:39 av .
- FörfattareInlägg
- 2020-12-24 kl. 12:20 #76746
Sorry another newbe question. My TD5 has an oil leak, I would say it is dropping around half and egg cup of engine oil after each run. I thought I had tracked it down to the back of the cam cover, especially given the amount of oil of the sound proof cover, but no. I cleaned the back of the cover and head and went for a run and no leak from there.
It appears to becoming from the rear of the Engine on the passenger side, but I just cant track it down. Its not the oil filter or the front came cover, either. See photos. Any advice please team.
Merry Christmas and a Happy seeing off of 2020.
- Detta ämne redigerades för 3 år, 9 månader sedan av .
- Detta ämne redigerades för 3 år, 9 månader sedan av .
2020-12-24 kl. 12:53 #76757Hi,
There is two common fails for leaking on the rear right side of engine. The most common leak is that the fuel pressure regulator leaks (diesel) you can see it if the engine runs checking in that area with o torch. But if you are sure that it’s engine oil leaking thats not it. But in nine cases of ten this is the problem. see pic 1
The other common fail is the gasket between the cylinder head and the cover. In rear end there is a halfmoon-shape on the gasket, this is little tricky to get fit when you reassamble the cover. see pic 2
2020-12-24 kl. 15:38 #76764My bet is on the fuel pressure regulator…
2020-12-24 kl. 16:09 #76766Thanks Per,
I dont think it is diesel, I am losing engine oil, appox 1lt every 2k. I will change out the came cover gasket, just waiting for the injector loom. Its also leaking oil into the ECU, which I have to admit upsets my Mrs less than the oil on the drive… May be one alternative is to hang a drip tray from the bottom on the chassis : )
Thanks for the advice, appreciated. Merry Christmas.
All the Best Michael
2020-12-24 kl. 16:11 #76769I was getting air into the fuel system a few weeks back, may be I should check to torque on the regulator. But to be honest it does not smell of fuel and looks very much like engine oil which I am losing an a regular basis. Merry Christmas
2020-12-24 kl. 16:18 #76770[quote quote=76764]My bet is on the fuel pressure regulator…[/quote] This is the oil after two trips. Its has the viscosity of oil.
2020-12-31 kl. 16:05 #77186Hi Jannes,
Happy New Year. I have been a bit busy with changing the fuel pump, so the oil leak took a lower priority. But now I have ordered some florescent marker oil and a UV torch.
My plan is to remove the belly plate and get it up on a lift and have a proper look-see.All the Best Michael
- Det här svaret redigerades för 3 år, 9 månader sedan av .
2021-01-01 kl. 14:17 #77230Johannes,
You were completely correct, it is the regulator. I did not notice it before, but I just changed the fuel pump and the improved pressure is causing a very noticeable drip, drip.
Next Job…All the Best Michael
2021-01-01 kl. 14:35 #77231hur byter man fuel pressure regulator…skruvar bort stycket med anslutningsslangarna ? och sedan ?
nyfiken eftersom troligen vår Defender Td5:a -00 åxå läcker diesel…2021-01-01 kl. 15:31 #77235Hi Denis,
This is the guy I go to on YouTube https://www.youtube.com/watch?v=Bpm8aQTIM64 My main worry is getting the bolts out as everything else on the Landy has been over tightened.
2021-01-02 kl. 09:45 #77276Hi Michael and Thanks !
Best of luck to you !2021-01-06 kl. 19:34 #77505So the fuel leak was a damaged O ring on the pressure regulator. What a fun job getting the regulator off .. : )
- Det här svaret redigerades för 3 år, 9 månader sedan av .
2021-03-11 kl. 15:55 #80831Hi Per,
Thought I would just give feedback, so I changed the sump gasket, cam cover gasket, refurbished the fuel regulator and oil was still pissing out. Change the crank seal yesterday, the ribs were warn flat. Not leak now. I am a happy man : ) But not a job. I want to repeat any time soon…
2021-03-11 kl. 16:18 #80834Just to close this story, in the end the oil leak turned out to be a warn crank seal. Had to get help for this one from Ground Zero 4 x4 as way above my skill set. Was very happy with them by the way. Fitted single mass fly wheel and clutch from LOFClutches at same time so happy now.
2021-03-11 kl. 17:53 #80848skönt att det löste sig!! skälv är jag för snål och fattig för att lämna bort nåt… och som tur är kan jag använda verkstan på jobbet…
men just nu är det kompisens D1a som jag renoverar motorn på…
och innan det var det en annan kompis Freelander2a som fick nya glödstift och startmotor…
men hoppas jag kan ta nån av mina snart!! - FörfattareInlägg
- Du måste vara inloggad för att svara på detta ämne.