Cry For Help TD5 miss fire

  • Detta ämne har 22 svar, 5 deltagare, och uppdaterades senast 2020-12-30 16:59 av .
Visar 8 inlägg - 16 till 23 (av 23 totalt)
  • Författare
    Inlägg
  • #76951
    Michael Hands
    Deltagare

      Hi Per,

      Sorry I should have mentioned left hand side. I wish I had been in Sweden when you guys change to the right hand side of the road, I bet they were interesting day.

      I will check the boast pressure, then have a go at freeing up the waste gate and see if it changes. I really hope this is the issue and not electrical.

      All the Best Michael

      #77001
      Michael Hands
      Deltagare

        Hi Per,

        The saga continues. I freed up the siezed turbo waste gate, some improvement but not a lot. I ran the diagnostics and the manifild pressure is 98.1kps engine stopped and 106.2kps engine running at 1900 RPM. See attached I cant get the engine to rev over 1900rpms. Any thoughts.

        All the Best Michael

        #77006
        Michael Hands
        Deltagare

          Double upload in error.

          • Det här svaret redigerades för 3 år, 11 månader sedan av .
          #77013
          Anders Lind
          Deltagare

            Are you sure you checked the crankchaft sensor – Google and you Will se where it is

            #77107
            Michael Hands
            Deltagare

              Hi Per,

              Sorry for the delay in responding, I thought I had posted a response but it did not upload. So the manifold pressure is around 98 engine stopped and only 106 engine running. But I pulled out the fuel pump and found this, so I hope this is the issue. I went though the floor as dropping a tank is not an option. All good fun )

              All the Best Michael

              #77118
              Michael Hands
              Deltagare

                Hello everyone,

                Thanks for all the advice. In the end it turned out to be the fuel pump. Given the weather I acessed the pump through the floor. All went well and a bit easier that droping the tank in the snow.

                All the Best Michael

                #77121
                Michael Hands
                Deltagare

                  Sorry double entry.

                  #77133
                  Michael Hands
                  Deltagare

                    Hello All, case closed,

                    So I found the issue, one of the brushes was burn out, likely due to the extra load on the pump with all the grunge in the filters.
                    Amazing hobby we have.

                    All the Best Michael

                  Visar 8 inlägg - 16 till 23 (av 23 totalt)
                  • Du måste vara inloggad för att svara på detta ämne.